Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 14

Threaded View

  1. 01-29-2015, 02:38 PM #1
    usarmyaircav
    usarmyaircav is offline
    Technologist
    Join Date
    Aug 2014
    Location
    Oklahoma
    Posts
    191
    Add usarmyaircav on Google+ Add usarmyaircav on Thingiverse
    Send a message via Yahoo to usarmyaircav

    Printing issue help

    Went to print out the x carriage piece for clough42's fan mount.
    I3v 10" Hexagon 1.75. Makerfarm Blue 1.75 ABS Sliced in both Cura and tried with Slic3r 1.1.7. Both looked good when slicing. Hotend at 235, Bed at 90 ( PEI sheet mounted to Glass). Other prints have worked well.

    2 changes I have made is the z endstop to using this - http://www.thingiverse.com/make:116574, and ZennMasterM's fine tunning part 2, which mine came out to be 91% for this roll of filament. Thoughts and suggestions?

    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules