Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 42

Threaded View

  1. 01-24-2015, 01:23 PM #23
    printbus
    printbus is offline
    Staff Engineer printbus's Avatar
    Join Date
    May 2014
    Location
    Highlands Ranch, Colorado USA
    Posts
    1,437
    Add printbus on Thingiverse
    Quote Originally Posted by bkmartin View Post
    I can swivel my hexagon 1.75 by hand. Is it not supposed to swivel?
    I wanted mine snug to minimize the chance it could wobble back and forth at all as the movement direction changed. I added a few layers of kapton tape to the round end of the hot end as required, trimming out a round hole for the filament to feed through.

    I didn't think the hex hot end fit in the grooved plate as well as it could have.
    Last edited by printbus; 01-24-2015 at 01:48 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules