Quote Originally Posted by DarkAlchemist View Post
So, do you or do you not?If you haven't had a part soft immediately after printing then you are lucky or you don't do ABS very much.I never did get a reply back from metalsupermarkets.com for my plate and I have to say they were the dumbest metal shop I have ever talked to since at least the Internet came to be.
'Pull off' as in remove I rarely have to touch anything as I said the cooling and the plate quickly (shrinkage) and then flexing and the parts fall off. And I print about half and half ABS and PLA. Must just be lucky, or by the time I touch them they have cooled off enough to be firm. I also have the bed slowly drop down in 5 degree increments to 80 after the layer 100 on most prints