Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
04-18-2016, 06:56 PM #10
Does anyone have good instructions on how to install the glass bed plate corner holder with screws? I assume they don't use the stock screws and I have M3 wingnuts, M3x8, M3x12, and M3x16 screws on hand.
g.gregory,
I have performed the fix per Qidi's instructions and have not seen an improvement yet. I have reached out to them again and will await their response as the creaking is getting quite bothersome but the prints are still churning out.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)