I have been meaning to put together my IBDE for a few days now but I have to wait for two .3mm hexagon nozzles (yes, I broke one off somehow) so I am on the stock configuration as I await with anticipation (will have to order a hexagon block as well if I can't get a bit of brass left by the broken nozzle).

But (of course) I am having a bit of trouble managing to print the double hexagon shroud and (to a certain extent) the part cooling double shroud;
- I cannot manage to remove this part without breaking it (LOL) under a 0.2mm layer height setting so I printed it under 0.3mm and managed not to break it:
https://www.dropbox.com/sc/xmgcu6c9o...-L3FF8T5Y_dzPa
Looking for tips on how to manage a strong 0.2mm layer height (I would love to get a good slic3r config, might as well).

- As for the part cooling double shroud, I think I may be extruding too much filament;
The part that interlocks with the IBDE (the shroud mount) came out a bit bigger than expected (or is this expected - just need to shave it down I guess).

All of my parts (so far) have been printed with Black ABS from MakerFarm.