Results 1 to 10 of 32
Thread: SgtToe 12" i3v Build Thread
Hybrid View
-
04-02-2015, 07:37 AM #1
- Join Date
- Mar 2015
- Location
- Wi
- Posts
- 9
I just built mine a couple of weeks ago, I used the hexagon fan shroud that came with it. I had issues with abs warping, then I turned the fan around and pulled the air and then the warping went away.
My girlfriend was not happy with it begin on the kitchen table. Its been there for a couple of weeks now and the complaints have lessened. I should probably think about moving it, but not sure where to. The build took me about 12 hours, but I'm slow and and like to over think.
-
04-02-2015, 12:32 PM #2
- Join Date
- Apr 2015
- Posts
- 9
Nice. Yeah I'm really excited about the 12" print volume but a little nervous that I'm not going to find a convenient place to put it. Meaning I'll likely have to calibrate every time I go to print something. Who know's though, maybe she'll find a use for it too and then I could just leave it in the living room .
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion