Quote Originally Posted by Talon 3D View Post
I can switch to the left extruder. I only went as high as 230 as it said it could take it LOL
https://meltink3d.com/shop/pla-pha-f...apha-filament/

I have been looking at making a new fan shroud to cool. Thingiverse has a nice looking one. http://www.thingiverse.com/thing:1484546

I will switch sides and lower the temp and see what I get.

S3D does make it easier to choose and use either extruder than makerware did that is for sure.
The PLA/PHA material appears to be similar to the Makergeeks Raptor series of PLA filament. I do print the Raptor stuff at 230. It prints kind of like a cross between PLA and ABS, has much better high temp characteristics than straight PLA, and needs to be "annealed" at 100C for 5-10 minutes after it is printed for max strength and temp stability.

The fan shroud you id'd comes in from the front side of the printer and will block your view of the nozzles. Here are some other choices and tradeoffs:
http://www.thingiverse.com/thing:1542849 dual rear uses existing blower
http://www.thingiverse.com/thing:1695189 dual rear reqs 2 x blowers on back
http://www.thingiverse.com/thing:1716089 Single, uses existing blower, improved ductwork for left blower