Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 39

Thread: Auto leveling

Hybrid View

  1. 07-28-2014, 11:38 AM #1
    clough42
    clough42 is offline
    Engineer clough42's Avatar
    Join Date
    May 2014
    Location
    Meridian, ID
    Posts
    418
    Has anyone else had issues with the probe striking the bed when extending and retracting? I had to modify my firmware to raise the Z axis 2mm before retracting. It's an ugly hack (raise 2mm, retract servo, lower 2mm) and I'm not super keen on releasing it in its current form.

    Anyone else dealt with this?
    Reply With Quote Reply With Quote
  2. 07-28-2014, 11:57 AM #2
    RobH2
    RobH2 is offline
    Super Moderator RobH2's Avatar
    Join Date
    Nov 2013
    Location
    Baltimore, MD
    Posts
    897
    Add RobH2 on Thingiverse
    Quote Originally Posted by clough42 View Post
    Has anyone else had issues with the probe striking the bed when extending and retracting? I had to modify my firmware to raise the Z axis 2mm before retracting. It's an ugly hack (raise 2mm, retract servo, lower 2mm) and I'm not super keen on releasing it in its current form.

    Anyone else dealt with this?
    Yes. There is a long thread discussing aspects of this that Roxy is doing a lot of work on. Try this thread: http://3dprintboard.com/showthread.p...1267#post21267
    Bambu P1S/AMS
    NVision4D http://nvision4d.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules