Ideamaker or Cura?

[Roberts_Clif]

They released Cura 3.0.3

[mjf55]

They released Cura 3.0.3

Went to it yesterday. I like what it does. Made some prints BETTER than the S3D version. Very impressed.

[Roberts_Clif]

Have you tried a print with infill twice as thick as the shell yet.

You get a really smooth finish ( outer shell ) print with half the print time, and the strength by using the thicker infill layers.

[mjf55]

Have you tried a print with infill twice as thick as the shell yet.

You get a really smooth finish ( outer shell ) print with half the print time, and the strength by using the thicker infill layers.

Not yet, but I will on my next print Are you referring to "Infill Layer Thickness" in the Infill section and "Layer Height" in the Quality section? So if I am printing a 0.3 mm layer height, use an infill later height of 0.6?

Thanks