Qidi Tech 1 - Replicator 1 clone

[cncartist]

Hey Guys,

Looks like I shot myself in the foot again. The Glass from McMaster doesn't fit the Maghold platform. The glass is way too small. Any way I can remedy this or do I need to get a new glass plate?
IMG_20160419_010520.jpg

Thanks.

If possible, redesign the corner pieces to support the glass for your setup?

[kaznad]

If possible, redesign the corner pieces to support the glass for your setup?

I wish I can do that, but I am too much of a noob. Just got into 3D printing. But even if I redesigned it, switching to the spring plates will be a problem as I would have to remove the clips.

On another note, the Octoprint thing screwed me, after restarting the Raspberry Pi what ever setup I did has gone haywire. To think I spent hours getting the exact point to do the bed levelling, I guess my OCD got the better of me.
I will try again later maybe.