Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Hybrid View
-
03-12-2016, 02:33 AM #1
- Join Date
- Feb 2016
- Posts
- 11
I tried a less permanent version (see photo - there is a mirror version on the other side). It makes some improvement in ringing on a box test structure, so I think further improvements with either a better printed part than my sketch, epoxy or a redesign will help.
supports.jpgIMG_4667.jpg
-
03-12-2016, 11:50 AM #2
- Join Date
- Feb 2016
- Location
- Texas
- Posts
- 18
-
03-12-2016, 12:58 PM #3
-
03-12-2016, 11:20 PM #4
I took mtnride's idea and made my own inserts to go at the bottom of the guide rods. Not sure if it makes a difference but I figured that it couldn't hurt. I can post it on Thingiverse but I'd prefer to get mtnride's OK before doing so since it was his idea.
20160312_203755.jpg
-
03-13-2016, 09:59 AM #5
Again nice work I was thinking along the same lines just hadn't gotten around to modeling it yet. Since my CAD skills are still in the beginning stages I may have to borrow your design.
Also not sure if this is really a problem my CTC with arm stiffeners has more side to side then my Qidi and it's prints look just as good.
-
03-13-2016, 12:56 PM #6
- Join Date
- Feb 2016
- Posts
- 11
These are great! I posted mine to thingiverse (it was a 20 second sketch) but I imagine these will work better if these guide supports are doing anything. I'm collecting the accelerometer data today (put together the metrology system yesterday.)
http://www.thingiverse.com/thing:1412591
-
03-13-2016, 02:19 PM #7
Posted mine as a remix:
http://www.thingiverse.com/thing:1412738
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help