Results 1 to 6 of 6
Threaded View
-
10-11-2016, 07:28 AM #3
The Zortrax Inventure is FDM-like (called LPD-Plus), as far as I know. So, it would be possible to get a mm/s value, or not? Maybe its similiar to the M200.?
The two SLA printers - yes thats clear that there is no mm/s number. I didn't wrote that well. But you could get a mm³/s number if you know the volume of the printed object (i.e. in mm³) and divide it by the printing time (i.e. in seconds). However, if the amount of time is reduced while printing more than one piece, hmm...
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion