Results 1 to 10 of 13
Threaded View
-
10-06-2016, 09:35 AM #9
60mm/s - not too fast - so it's probably not that.
I usually print pla at 65.
Wouldn't hurt to drop it to 50mm/s 3000mm/min, just to check.
Switch the display to mm/s - it's much easier to visualise how far it travels in one second. Almost impossible to visualise how far it goes in one minute :-)
What brand is the pla ?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion