Results 1 to 10 of 42
Thread: Pegasus 12" Build Notes
Threaded View
-
09-21-2016, 06:35 PM #21
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
Hi
Ok here's a shot of the dual extruder. I played with the thumbnail settings as suggested. It goes from tiny at "medium" to ginormous at "large". The printed part on top of the carriage keeps the wires from drooping down when the print is up around 350 mm tall. It seems to work pretty well . It is simply held in place by the wire ties on the cables. It's quite rigid, even done that way.
225_ - 1.jpg
Ok, that's not quite so overwhelming on a normal view as it is in the message entry box. Large it is.
BobLast edited by uncle_bob; 09-22-2016 at 12:27 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion