Results 1 to 9 of 9
Thread: jagged lines
Threaded View
-
09-06-2016, 04:06 PM #3
- Join Date
- Sep 2016
- Posts
- 4
Yeah, I mean its definitely possible I messed it up though. I figured that might have been the issue at first, but when I turned down the extrusion percentage it didn't get any better. I went down incrementally to 10% less. Also the issue is on and off. It happens on most prints but not on others. Even the same part can have the issue one time and not another with no changes in between. Most prints have the issue though.
MODERATOR NOTE: Late post due to delayed moderator approvalLast edited by printbus; 09-16-2016 at 10:29 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help