Results 1 to 3 of 3
Thread: re-homing Y axis
Threaded View
-
09-04-2016, 04:02 AM #3
- Join Date
- Aug 2016
- Posts
- 2
Hello,
having a similiar issue myself. Beside the fact it is my x-Axis which is off.
The result is the Printer moving to its starting coordinates - which are in my case in the right front - heating plattform and extruder up, but instead of starting the print and moving towards the printing bed it moves to the right until it hits the End-Up switch. (And wants to go further)
What have i already done:
-Played with the x-Axis Offset->No effect
-Losened the screws clamping the belt to the carrier and starting a print.
->The Belt gets pulled a long time, say 5mins, to the right then changing direction and starting the print.
So i guess its the starting point of the X-Axis wich is totally off bounds and doesn't got a reset by touching the End-Up-Switch.
Can someone please help?
Moderator note: Post is late to view due to unexpected delay in obtaining moderator approvalLast edited by printbus; 10-05-2016 at 06:43 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help