Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Hybrid View
-
08-31-2016, 09:53 AM #1
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Has anyone done an extruder calibration? Measure 100mm of filament and see if it extrudes 100mm? S3D suggested this due to an issue I was having so just wanted opinion from the group on this.
-
08-31-2016, 10:05 AM #2
That is for marlin software or repitier I think. 100mm of filament will extruded way more than 100 mm of filament.
Best filament calibration is a 20x20x10 100% infill cube. Follow sailfish recommendations for sailfish software.
In S3d a good starting point for extrusion volume is 90%.
-
08-31-2016, 10:26 AM #3
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
08-31-2016, 11:56 AM #4
-
08-31-2016, 04:21 PM #5
What nozzles do you guys recommend when it is time to replace them?
I have seen a few in here with the Swiss Micro looked great but expensive.Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help