Results 1 to 10 of 49
Threaded View
-
03-16-2014, 11:00 PM #34
Meow is right....puuurfect... I'm assuming you had no supports because the overhang was only around 20 degrees or something? Really clean. That's a Makerfarm printing at .10mm. Is that correct? Thirty-one hours, yikes... What was your perimeter speed? Had to be 15 or so to be so clean.
Bambu P1S/AMS
NVision4D http://nvision4d.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion