Results 1 to 10 of 49
Threaded View
-
03-16-2014, 08:23 PM #27
Cool looking part. Good to know what it is.
I can't wait to do some faster printing. Don't know why I haven't, just thought that I shouldn't go over 40mm/s. Not even sure where I got that. But, 70mm sounds exciting to experiment with. Yea, Cura rocks for me right now.
I did play quite a bit with Skeinforge. Man is it confusing to begin with. It took a lot of reading. I get good prints from it but nothing so far that Cura or Kisslicer can't do. One day I may find I need those very fine controls and Skeinforge will rescue me. But for now, it's just too much to deal with.Bambu P1S/AMS
NVision4D http://nvision4d.com
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion