Results 1 to 10 of 12
Thread: ABL Home Position Question
Threaded View
-
07-22-2016, 10:03 AM #6
Update: Commented out safe homing worked like a charm, thank you guys! My hotend is homing in the typical back left corner of the bed.
New question: I tried a first print after sending a G28 and G29 and it seemed level across the bed (amazing) but the height was a little too high where the first layer wasn't squishing. In a typical pre ABL Z endstop I would just change the height of the endstop switch, is the new ABL done by changing a parameter in Configuration.h and reflashing?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)