Results 1 to 5 of 5
Threaded View
-
06-24-2016, 01:02 PM #3
- Join Date
- Feb 2015
- Posts
- 371
It does this with other rolls too. I will bump the filament a bit. I was thinking perhaps I have too much retraction? I have been looking at the patterns and see that it may be at a transition point in the print that these show up.
Also, I use matter control. It used bit of the slicer engine but I find I get much better prints with this software than with slic3r.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help