Quote Originally Posted by curious aardvark View Post
you're extrusion width is 0.8 !

Wow. that's pretty extreme.

Next time you load some filament. take your digital calipers and measure the extruded plastic's diameter.
That's what your extrusion width should be set to. With a 0.4mm nozzle it's usually between 0.4 - 0.55.
0.8 is just serious over extrusion.
Its only been set to 0.8 since yesterday as i read somewhere it should be double your nozzle,... which i thought was strange. Before that ive always had it at 0.5 but still have same problem at 0.5 and even at 0.54. I set it to 0.4 still have the same problem im afraid

I did all the caliper stuff on a 10cm length. I did the cube test print and it does come out at 0.98 to 1mm exactly.

I will try 0.55 and some lower settings