Results 1 to 10 of 10
Threaded View
-
06-24-2016, 06:25 AM #6
- Join Date
- Apr 2016
- Posts
- 12
Its only been set to 0.8 since yesterday as i read somewhere it should be double your nozzle,... which i thought was strange. Before that ive always had it at 0.5 but still have same problem at 0.5 and even at 0.54. I set it to 0.4 still have the same problem im afraid
I did all the caliper stuff on a 10cm length. I did the cube test print and it does come out at 0.98 to 1mm exactly.
I will try 0.55 and some lower settings
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion