Results 1 to 6 of 6
Thread: Filament as it gets older
Threaded View
-
06-20-2016, 10:26 AM #4
- Join Date
- Feb 2016
- Location
- Durham, NC
- Posts
- 20
Higher Temp
At the higher temp, the filament flows better. That gives it more time to seep into the cracks of the tape.
But, did you try printing that first layer .1mm closer to the bed?
After 6 months, the printer has changed much also. Maybe not much but some.
If you REALLY wish to experience not sticking, switch to ABS...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion