Results 1 to 10 of 14
Thread: Installing the glass bed
Threaded View
-
06-09-2016, 08:57 AM #5
I will try to post a picture wen I get home from work. I will say I have tried it a few ways. I have tried it 2 ways. The first time I cut the sheet to to fit the whole bed and the heat transfered with no problem. Then when the glass chipped on me and I replaced it, The second sheet of glass I cut the padding into 4 1in x 6in strips and left a space in between each strip and there was no difference in the two ways I did it. Both ways transfered the heat fine.
Well I was going to post an image but for some reason the forum will not let me post it. I have sized it down to 200x87 and it is only 24KB. I tried both ways as a file and with a url.Last edited by rforeman; 06-10-2016 at 08:04 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion