Results 11 to 16 of 16
-
06-04-2016, 12:14 PM #11
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
No No,the TF-card is the little micro sd card on the motherboard.When you transfer the G-code via usb it will be stored on this internal flashcard.I know Flashforge has change de VID and PID for usb after a firmware update.So we can not use Simplyfy3D anymore over usb.And what is Flashforge doing to solve this problem?Totally NOTHING.We wait for months now to use Simplyfy3D over usb.I rolled back to a previous firmware to use the software. You can see the threat in the link.
Oke but that is not solve my problem.I am a CNC engineer so I think I have to check the G-code in the file.
https://forum.simplify3d.com/viewtop...hforge+dreamer
-
06-04-2016, 06:45 PM #12
Ah ok, thanks for the information, and holy cow what a mess.
So I take it that the control set does not copy the .gcode to the TF-Card when printing from the SD card??? If that's the case then I think you are on the right track with your diagnostics, and a closer look at the TF-Card is needed. If the control set does copy the .gcode to the TF-Card when SD-Card printing then I think the problem is unrelated to the TF-Card. I know, I know,... Not giving you any help/information you don't already know..
Please let us know how you make out.
-
06-04-2016, 11:35 PM #13
Hmm very odd issue indeed, I wish I could be of more help, but since the dreamer is then streaming it's own file after the gcode export, it's hard to tell exactly what it's doing.
is that big blob in the corner of your print a result of it being knocked off, or is it the reason it was knocked off?Hex3D - 3D Printing and Design http://www.hex3d.com
-
06-05-2016, 05:23 AM #14
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
The blob is the result of crashing from Z-axis into the print not from knocked of the print..I suspect that if it crash it also extrude a lot of plastic at the same time.I went to the G-code file and found sofar nothing strange.I saved the file from the internal micro sd card to my computer.I will copy that file to the external Sd card and run that file...see what happens.I think I have to inform Flashforge also.
-
06-05-2016, 05:58 AM #15
- Join Date
- Feb 2015
- Location
- Netherlands
- Posts
- 15
PHP Code:[PHP][PHP][PHP]
Thank you guys to think with me!
-
06-09-2016, 12:29 PM #16
so is the print starting for a few layers and then the z axis goes into reverse - or does the z axis just not drop.
I did some research and I found out when I slice with Simplyfi3D and save the G-code on the external SD card all is fine
I mean if doing it one way means it works and doing it another way means it does not work - then don't do it the way that doesn't work.
What do you expect to gain by using the method that doesn't work - ie: why persevere with it ?
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help