Printer Calibration Help (Printrbot Simple Metal w/ Heated Bed)

[UnholyJester]

I've just recently purchased a Printrbot Simple Metal with a heated bed, and have been messing with it in my free time for the past week now. I opted to use Slic3r and Repetier, since Cura was working, but didn't allow for a lot of customization. I'm slowly getting better prints, but I've hit a point now where I'm not sure how to proceed.

Here is a 5mm steps print that I did last night:

http://imgur.com/a/ENHgj

and here is the Slic3r settings I'm using:

http://textuploader.com/5b4a3

(Sorry for not directly attaching them, the message editor was not working properly for me)

Any help on what settings I can tweak to get better print quality would be appreciated.

--------------------------------------------

Edit (05/23/16) -

I did a bit more tweaking and adjusted the Slic3r file to the following:

http://textuploader.com/5blkf

And have been getting some good prints, but now I'm having issues with higher resolution prints. When printing at 0.05 -> 0.2mm / layer, I'm not getting filament extrusion. 0.3mm / layer seems to work fine, but anything less either doesn't extrude filament, or extrudes it in blobs. This is a print at 195* first layer (185* for the rest) w/ the heated bed at 65* first layer (55* for the rest).

http://imgur.com/leky6Y6