About to try Marlin1.1.0RC4...

[lakester]

I can share my current Configuration.h.

It is compatible with the RCBugFix branch of Marlin as of this writing, though you should review the diffs before applying them to your system.

It is configured for the following:

• Makerfarm I3V 12"
• RUMBA
• Hexagon HE (w/ associated thermistor)
• Standard LCD (i.e., not the "graphical"/big display)
• Manual Mesh Leveling is enabled.
• SD Card support is enabled.

It also includes optimizations based on the work of printbus:

• http://3dprintboard.com/showthread.p...ll=1#post41192

The entire thread is worth reviewing.

Keep in mind you may need/want to tweak your slicer settings to align with the printbus changes.

I also made some minor tweaks regarding some dimensional settings, to allow for clips..., etc. I will probably revisit some of those changes in the future, but for now, they work for me.

I've attached the file..., hopefully it arrives intact.

Good luck! -- John

Configuration.h

Does anyone have config files for Makerfarm I3V 12" with Marlin RC6 mesh and Rumba they can post ?