Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Hybrid View
-
04-18-2016, 09:19 PM #1
-
04-18-2016, 10:06 PM #2
- Join Date
- Mar 2016
- Posts
- 45
I wish I can do that, but I am too much of a noob. Just got into 3D printing. But even if I redesigned it, switching to the spring plates will be a problem as I would have to remove the clips.
On another note, the Octoprint thing screwed me, after restarting the Raspberry Pi what ever setup I did has gone haywire. To think I spent hours getting the exact point to do the bed levelling, I guess my OCD got the better of me.
I will try again later maybe.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion