Quote Originally Posted by bluemeane View Post
I have absolutely NO problems with BuildTak. I have even used it to print ABS on my Fabrikator Mini without a heated bed. I have used Glass in the past, and still prefer my flexible plate with BuildTak any day. I can pull it off literally RIGHT after a print finishes, and within seconds it is cool to the touch and the part is off the bed and I am ready to print again (Although I usually use a different plate because I have several ready to go. )
Pulling a part off that soon would ruin the stuff I do as internal holes, etc... would deform. Nothing worse than to grab on to a print and leave an indent where my thumb was. :/