Results 1 to 10 of 125
Thread: 10" Pegasus Build
Threaded View
-
04-13-2016, 10:11 AM #18
I checked on my print and found the printer was printing in mid-air with nothing coming out of the hotend. Upon further inspection I found the hobbed gear all clogged up with ABS fragments and it was just slipping on the filament instead of driving it down through the hotend. I initially was worried that reversing the heatsink fan had caused problems but I was able to manually extrude by pushing down on the filament.
Here is a pic of the filament. Do the marks show too much or not enough tightness on the hobbed gear/idler? Or maybe this is caused by something else...
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion