Results 1 to 9 of 9
Threaded View
-
04-11-2016, 07:32 PM #5
- Join Date
- Apr 2016
- Posts
- 6
Thanks for your reply.
Well, I built the printer in a workshop so before doing anything, we checked everything but after that have not done any calibration. I am new to 3D printing so do not know how to calibrate.
Yes, it prints as you described. I also attached new pictures and apparently, the problem is only the front part (towards to front). It seems that when it finishes a layer and comes back to start a new layer, it kind of pushes a little more filament. Yes, this might be still an issue about retraction.
I have not had any issues with the printer bed but I will keep an eye on it.
Retraction:
Length: 2.5mm
Lift Z: 0
Speed: 40 mm/s
Extra Length on restart: 0
Min. travel after retraction: 3 mm
Retract on later change: checked
Wipe while retracriong: unchecked
3D Printer Problem1_IMG_5862.jpg3D printer problem2_IMG_5861.jpgLast edited by DreaMPoweR; 04-11-2016 at 07:52 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion