Results 1 to 2 of 2
Threaded View
-
04-05-2016, 08:52 AM #2
Before you screw the nozzle back in use some form of locking grease (not threadlock) just something to block small gaps in the thread. CPU thermal paste is what I use, as it has such a high temperature resistance. I use the paste on the nozzle thread when I screw it in, and screw it in tight! this should stop the ooze from above.
Hex3D - 3D Printing and Design http://www.hex3d.com
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion