Results 1 to 10 of 95
Thread: 12" I3V Build
Threaded View
-
02-19-2016, 02:40 PM #11
- Join Date
- Nov 2015
- Posts
- 73
So didn't work out that 0.2mm shims worked every time, but with enough playing around with combinations of shims I got all the wheels turning completely smooth after being really torqued down tight with no side to side play. I highly recommend picking up some shims, the extra effort is well worth it (5x7x0.1 : 5x7x0.2 : assorted set) Should finish up most of the mechanical assembly this afternoon and later tonight, then it's on to assembling the extruder/hotend and wiring it.
The relay had solder on both sides of the board and I was unable to get it cleanly removed. Ended up cutting it off and then getting the pins left behind out. Little work with a reamer and a 14 gauge sold copper wire just fit in the hole. Got that soldered up and continuity still checks out.Last edited by Dustin B; 02-20-2016 at 09:43 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help