Results 1 to 7 of 7
Thread: Marlin RC SD problem
Hybrid View
-
02-12-2016, 04:51 PM #1
- Join Date
- Feb 2016
- Posts
- 5
Goes into hit endstop without moving. Uncommented the manual endstop. Inverted the switch logic and everything works. Really work good with the Simplify software. Thanks for your help.
Last edited by protoquick3d; 02-13-2016 at 10:52 AM.
-
08-01-2016, 01:34 PM #2
- Join Date
- Jul 2016
- Posts
- 1
on my controller the sd card doesn't work either.
with my ramps i have the following problem --- when i want to move the X it works but when i want to move the Y the Y doesn't work but instead the X turns .... does anybody know how this is possible ?
thx
Moderator note: Post is late to appear due to unexpected delay in obtaining moderator approvalLast edited by printbus; 10-05-2016 at 06:59 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help