Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 24

Hybrid View

  1. 02-02-2016, 09:39 AM #1
    jfkansas
    jfkansas is offline
    Super Moderator
    Join Date
    Apr 2014
    Location
    KS
    Posts
    907
    Add jfkansas on Thingiverse
    The enclosed chamber doesn't have any temp effects underneath the printer. The stepper drivers don't run at full capacity so they don't get hot. The fan was a failed attempt a long time ago, think 2012ish, to fix a problem. The clone manufacturers just had the fan because the original design had one. The Chinese aren't very good at designing 3d printers, but they are good at copying... sometimes they even copy a bad design from the start.
    Reply With Quote Reply With Quote
  2. 02-02-2016, 09:55 AM #2
    Sebastian Finke
    Sebastian Finke is offline
    Super Moderator Sebastian Finke's Avatar
    Join Date
    May 2015
    Posts
    989
    Quote Originally Posted by jfkansas View Post
    The enclosed chamber doesn't have any temp effects underneath the printer. The stepper drivers don't run at full capacity so they don't get hot. The fan was a failed attempt a long time ago, think 2012ish, to fix a problem. The clone manufacturers just had the fan because the original design had one. The Chinese aren't very good at designing 3d printers, but they are good at copying... sometimes they even copy a bad design from the start.
    Well hallelujah! Disconnecting!

    Reply With Quote Reply With Quote
  3. 02-02-2016, 11:31 AM #3
    EagleSeven
    EagleSeven is offline
    Engineer EagleSeven's Avatar
    Join Date
    Jul 2015
    Posts
    553
    * Well Hallelujah! *
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules