Results 1 to 10 of 22
Thread: FET Bed Heater Board
Threaded View
-
02-01-2016, 06:11 PM #8
- Join Date
- Jan 2016
- Posts
- 34
Im actually thinking of following in TechMasterJoe footsteps and using an ATX power supply. For me atm its hard to guess what will and will not be useful, I just got the check today that will be going toward my 10" Pegasus, I have spent the last week or so just looking at things I plan to change from the start. The Mosfet Driver seems to be the easiest to tackle and I can see it being used for other things, I just ordered 3 boards and parts today. p.s. I can see some Chinese guy making and selling them for $3 in a few weeks time lol.
I will say the ATX power supply's nowadays can give more then 1A in standby on the 5V line, this can power all the small stuff until the controller decides it needs more power and turns the supply on. I also looked at reworking the Ramps 1.4, but thats a long battle for later.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion