Results 1 to 3 of 3
-
01-09-2016, 03:54 PM #1
- Join Date
- Jan 2016
- Posts
- 2
Need Help With My 3D Printer! I have Photos!
Hey, I need some help getting the right settings for my printer. My printer is a Monoprice Maker Select. It's pretty much a re branded Prusa i3 . I have a picture of what is wrong with my print below. I am printing with ABS at 230c with a bed temp of 90c. I am using the program CURA. I did post in the "tech help" forum but nobody responded. Any help would be great! Thanks!
0109161150a_HDR.jpg0109161150_HDR.jpg0109161110b_HDR.jpg0109161110a_HDR.jpg0109161110_HDR.jpg
-
01-09-2016, 05:00 PM #2
My first suggestion is to use PLA filament, at about 205C, Instead !
230C is too High, even for ABS
(if that is actual temp at nozzle)
(sometime actual is higher than indicated at printer display)Last edited by EagleSeven; 01-09-2016 at 05:08 PM.
-
01-09-2016, 05:04 PM #3
Just a guess, try lowing your extruder temp to 220, and slooooow down your print.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion