Results 1 to 10 of 53
Thread: New CTC Owner
Threaded View
-
12-29-2015, 01:39 PM #12
- Join Date
- Dec 2015
- Posts
- 80
Aha! I think I might have figured out whats wrong. Or part of what's wrong.
The front Y axel may be moving slightly as it isnt fixed.
The back one seems fixed.
So question now is how do I tighten this up?
This is axel pushed to the right
20151229_193824.jpg
And then axel pushed to the left
20151229_193837.jpg
As you can see a gap appears. between the spacer and gear.
edit: nevermind, I printed washers with the axel pushed left and right, prints came out pretty much identical, still oval
OK so read a thread which say it could be the firmware needing reflashing, so updated to 7.5, will update to sailfish later and then do a test print againLast edited by bigo93; 12-29-2015 at 08:04 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help