New CTC Owner

[bigo93]

Oh I thought via SD was better as you dont have to worry about random disconnects.

Got another test print going, but again, the ABS is not sticking well to the plate.
Even used double sided sellotape on it! The corners are still coming off :'(

Gonna let this print anyway, and hope the slight warping doesnt affect them.
And if they dont then hopefully glass plate will work and I can reprint them after.

Also I am using the Markerware software I doubt it will have problems slicing.
Maybe it's the firmware on the CTC, it's still on the one it came with, v1.0; maybe if I upgrade it to sailfish it would help? But read mixed views on upgrading it with a couple people saying they have bricked theirs...

And thanks for the reply, wasnt expecting any for a couple day, Merry Xmas!

But also wont the PLA melt or warp slightly if you use it to make these bed extenders?