Results 1 to 10 of 32
Thread: R.I.P. Power Supply
Threaded View
-
12-10-2015, 09:12 PM #8
- Join Date
- Aug 2015
- Location
- Vail, CO, USA
- Posts
- 36
Open the power supply and send a picture here on the forum and we can help identify it for you.
Let me know if anything is amiss.
I assume you're using one of the usual 12V 30-amps or so switching power supplies that fit the mounting hole pattern on the MakerFarm printers.
If the fuse is good or burns open again after replacement, I'd look for a new power supply.
P.S. Yes the fuse is completely intact if you can't tell from the tiny picLast edited by spaceorange12; 12-10-2015 at 09:13 PM. Reason: Clarification
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion