Quote Originally Posted by Mjolinor View Post
Cura is the best slicer out there to start with (excluding simplify 3d as I have never used it.

Skeinforge, as you have used above, is very old but very capable though complex. The other option in RepG is Slicr3r which is quite good but changes a lot with upgrades and can be a real dog on some of the releases.

Cura does a better job than both of the above and I don't know where you read that it is the worst choice but I would suggest that whatever site you read it on you don't bother going back to.

Cura does not make X3G which is why I said in my post that you should make the Gcode in Cura then open it in RepG and make the X3G code. There is another option for making the X3G called GPX but I have never got it to work.
Ok,
Everyone always says to "GOOGLE" stuff...and I did. This is what happens sometimes.
I found quite a feww posts that said that CURA GCode is not compatible at all with a FlashForge Clone.