Results 1 to 5 of 5
Threaded View
-
11-23-2015, 10:23 AM #4
Just to be clear... I don't know the answer. There has been a lot of good success stories about using inductive probes but they always seem to be associated with very high dollar parts. Not a $5.95 part from eBay.
But what I do know for sure is even the cheapest micro-switch from China bought off of eBay will produce very good results if the rest of your mechanics are good. I am using almost the cheapest one possible. It looks like this:
http://www.ebay.com/itm/New-Roller-L...wAAOxycgVTfqZ2
And I can get .002 mm repeat-ability every time. Given I usually print with .28 mm layers, the micro-switch isn't the source of any problems I hit.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion