Results 11 to 17 of 17
-
11-16-2015, 02:06 AM #11
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Cura cannot talk to the printer. The printer needs an X3G file and Cura cannot make that, hence the need to convert from Gcode to X3G using RepG.
-
11-16-2015, 03:15 AM #12
- Join Date
- Nov 2015
- Posts
- 9
Hello...
That i know, i used a file converter from here... http://www.thingiverse.com/thing:81425
Using that converter the printer acts like i said...
Regards.
-
11-16-2015, 03:29 AM #13
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
I have spent hours trying to get that converter to work and had no success at all. A lot of people use it without any problems but not I.
-
11-16-2015, 05:16 AM #14
- Join Date
- Nov 2015
- Posts
- 9
Here is a new print... temp used 240 heat bed 55, no stick glue using makerware 2.4... i had to sand out some excessive material in some places to look like this...
20151116_105157.jpg20151116_105240.jpg20151116_110122.jpg20151116_111535.jpg
-
11-16-2015, 10:35 AM #15
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Well it is a lot better but I still think it is under extruding.
-
11-16-2015, 12:14 PM #16
-
11-16-2015, 12:30 PM #17
- Join Date
- Oct 2014
- Posts
- 441
Looks like it warped pretty bad. I had great luck with kapton tape and a very very slow first layer speed with ABS. I've just switched to glass bed with hair spray and thats working good also. Also, switch to Simplify3D
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery