Results 1 to 10 of 18
Thread: new to 3D printing, help please
Threaded View
-
11-04-2015, 05:45 AM #3
lmao - check the forum section before asking what printer :-)
Sounds like the bed material isn't as sticky to pla as it should be.
So you're getting a slight warp. Cheap pla will warp a bit.
Try rubbing a gluestick over it - pla loves pv-alcohol (the main active adhesive in glue sticks)
That will let the pla stick much better to the bed.
A couple layers should do to start.
I usually run the stick over the bed before a print and after removing one from the bed - that tidies up any gaps from pva sticking to the print.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help