Results 1 to 10 of 21
Thread: Raft bond too strong
Threaded View
-
10-19-2015, 11:35 AM #15
We used window glass purchased at Lowes-hardware.
Used Aqua-net spray to stick glass directly to aluminum plate, No tape
Use large paper-clips to hold it in place until dry, takes about a week to dry completely
Top of glass is about 15 C lower than indicated temp
Since adding glass, we do rafts only when large Support areas are needed,
for objects with overhang areas at bottom of object.
Use Aqua-net spray to hold printed objects to glass also, thin even coat is best.
(wash off spray, with wet cloth, after each print)Last edited by EagleSeven; 10-19-2015 at 11:55 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion