Results 11 to 13 of 13
Thread: Raft settings?
-
10-12-2015, 03:08 AM #11
Your need for rafts seems prompted by the use of ABS (significant warp ratio material). Have you considered moving to PET ? If yes, what repelled you ?
-
10-12-2015, 08:19 AM #12
- Join Date
- Jan 2015
- Posts
- 445
raft is TOOOOOOO sticky... raft sticks to bed just fine. sticks to part too much.
So i went all the way up to .5mm separation and it was a little easier to take off. not EASY per sae.
-
10-12-2015, 10:13 AM #13
- Join Date
- Jan 2015
- Posts
- 445
I do use some pet... I think what i like about abs is its easier to print. PETG is pretty hard to lock in, and if its not JUST RIGHT than the part doesnt work.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion