Results 1 to 4 of 4
Thread: Ridged prints from Prusa I3
Threaded View
-
10-06-2015, 06:52 PM #2
JFCooper3,
It looks to me like you are overextruding.
This might not be evident on layer one if the Z zero is a little lower than it should be - the extra flow will cancel out the extra space, but as you go up in layers there is not room for all the material, so it builds up along the sides of the travel of the head.
Davo
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion