Results 1 to 6 of 6
Thread: PowerSpec 3D Pro Thermocouple
-
10-03-2015, 09:45 PM #1
- Join Date
- Sep 2014
- Location
- St . Louis
- Posts
- 6
PowerSpec 3D Pro Thermocouple
Can anyone recommend a place to buy a replacement thermocouple for my PowerSpec 3D Pro printer?
-
10-04-2015, 09:01 AM #2
We got some for about $2. each on eBay.
Not sure if exactly the same as those in your printer but will probably work if yours needs K-type with the eye-lug end .
http://www.ebay.com/itm/5pcs-lot-Mak...item23583d0f9e
These are Great T-couples but come from China, so may take several weeks to get them.
Note: these have eye-lug on sensor end and are 1.5 meters long,
but other connections and lengths are available at eBayLast edited by EagleSeven; 10-04-2015 at 09:10 AM.
-
10-04-2015, 11:40 AM #3
- Join Date
- Sep 2014
- Location
- St . Louis
- Posts
- 6
Do you have anything comparable to this?
http://www.flashforge-usa.com/shop/thermocouple.html
I could get it from flashforge, but the price seems way too high....
-
10-04-2015, 12:09 PM #4
Sorry, only found one with that type end-connector at eBay,
it was a little lower price but the shipping cost from Australia makes it cost Much More
I did not realize Flashforge used that type Threaded sensor end.
I guess FF is making their own design, so they can charge More for it .
-
10-04-2015, 12:15 PM #5
- Join Date
- Sep 2014
- Location
- St . Louis
- Posts
- 6
Thanks for looking into it!
-
10-06-2015, 02:54 PM #6
I found this threaded type T-couple at eBay,
it may fit your printer ?
Thread diameter is 6.mm
Only 76 cents each
http://www.ebay.com/itm/1M-0-800-Scr...3D281791574734Last edited by EagleSeven; 10-06-2015 at 04:07 PM.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion