Results 1 to 9 of 9
Thread: Geeetech G2s Printer Kit Review
Threaded View
-
09-29-2015, 05:43 PM #6
The corner anchor is just positioned on the grid at the right spot in Slic3r. You would replicate it 6 times if you are going to use it and put one under each leg. Once the part is printed and off of the glass, you just take a razor blade and slice it off.
I'm going to print up your rod_end_shims(). I have a lot of wiggle on my effector.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)